![]() The difference is they 1) don’t take any electrical load, and 2) goes into your amp’s effects loop. Several companies actually make small pedals that act similarly to power attenuators. If you’re really looking to take your amp directly into your interface, you should get Impulse Response software. I personally think every single emulated speaker out on any hardware device is pretty worthless. It converts your amp’s signal into a line or mic level signal.īut, some power attenuators also have an emulated mic output or direct line out to go into a recording interface. You can think of them as DI boxes that can safely take an amp’s load. They’re intended to go directly into a PA or recording interface, and typically have a speaker emulation. Load boxes also take your amp’s electrical load, but unlike power attenuators aren’t meant to go into a speaker cabinet. It takes your cranked signal, safely handles the electrical load, and lets you turn the volume WAY down when you take it into your speaker cabinet. It sits between your amp and your speaker cabinet. ![]() They're kind of the same thing, but also different.Ī power attenuator can be thought of as a volume control. What are load boxes and what’s the difference between a load box and a power attenuator? If you’ve researched power attenuators you more than likely have seen load boxes pop up. You get the cranked up tone of your amp at a reasonable volume. You take your standard speaker output of your amp into the dedicated input on the power attenuator, then the speaker out on the power attenuator to your speaker cabinet. Sitting in between your amp and your speaker cabinet, the power attenuator takes your amp’s full signal and load, gives you a volume control, and then goes into your speaker cabinet. Even though it’s eventually connecting to a speaker cab, the load has to be dealt with early on in the signal flow in order for the volume to do anything. So in order to effectively control this volume, a power attenuator has to do the same. The speakers safely absorb the load from your amp. This is normally rectified (no pun intended!) by connecting to a speaker cab. That electrical energy has to go somewhere, it can't just sit in the amp. If you turned your amp on without it being connected to an appropriately rated speaker, you’d risk blowing it up. But with the AC30, I cut it back to 50-60% (I'm just guessing based on the needle position) and the tone is still there.Īnyway, like the other guy said.we are free to do what we want.A Power Attenuator is essentially a high-tech post-preamp and power amp volume knob. When my wife is not around I have it louder. When I use my Mesa Boogie, I almost always have it in 5 watt mode, so my Stomp volume control is only reducing the overall sound by about 20-30% if that. Also, and this probably goes without saying, but here I go.the cleaner the amp settings, the less impact the Helix volume control has on impacting the tone. But I guess in a gig setting if you're being told to turn down for any reason.Īnd fwiw, the amp opened up with the Helix wide open does in fact sound the best, but that's also freaken loud. I think the real application is in home use. ![]() Where in fact it does, but in no way is it unusable or a turn off. Well exactly! That's what I would expect, but when trying this out in a variety of 'real' amp settings, it doesn't seem to have a huge impact on the tone. Aren't you starving the amp input by lowering Stomp output volumes ?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |